4. System Operations
4.1 Front Panel Button Control
Refer to Section 2.1 Front Panel Appearance dependent on model. Basic Introduction on programming the Triax Matrices via
the front panel.
4.1.1 Switching I/O connection
To convert one input to an output: Operation "Input 1"+"Output 2"+"ENTER"
Example: Input 1 to Output 2
INPUTS
OUTPUTS
1
2
ENTER
3)
To convert an input to all outputs: Operation: "input" + "ALL" + "ENTER"
Example: Convert input 1 to all outputs
Note: Default setting, All IR OUT sockets correspond with the total number of HDMI INPUTS dependent on model. When you
convert an HDMI input to an output, the corresponding IR OUT will be switched synchronously.
2)
To convert an input to several outputs:
Operation: "input" + "output" + "output" +... + "ENTER"
Example: Switch input 2 to output 2 and 4
INPUTS
OUTPUTS
OUTPUTS
2
2
3)
To convert an input to all outputs:
Operation: "Input" + "ALL" + "ENTER"
Example: Convert input 1 to all outputs
INPUTS
OUTPUTS
1
ALL
LED programming sequence, The BLUE LED's will flash 3 times when the program sequence has been saved, If there is no
BLUE LED sequence the programming has failed.
4
ENTER
ENTER
17/52