Ir Control Setting - Triax HMX 442 LP4K User Manual

4.2.4 IR control setting

Control the devices located in the zones via the local IR commands at the sources location
Connect the IR emitter receiver to the IR IN port of the Triax Matrix. The users can now control the devices in the zone from the
matrix at the Source location. To enable this functionality a IR blaster needs to be plugged in to the IR Out socket on the HRX
1LP4K and has to be inline of sight of the device that you want to control.
See Schematic below (for illustration only):
To control ALL receivers in the zones a IR emitter needs to connected to the IR ALL IN port on the matrix and an IR Blaster/
transmitter connected to the IR Out socket on the HRX 1LP4K receivers. Once the commands are sent from the local source the
IR signals are modulated and passed through the CAT cable infrastructure before being demodulated at the receiver and blaster
out to the display. The Blaster must be in-line of sight of the display.
HRX 1LP4K 1
HDMI Lead
HDMI
Lead
HRX 1LP4K 2
HRX 1LP4K 3 HRX 1LP4K 4
IR Blaster
22
HRX 1LP4K
HRX 1LP4K 7
HRX 1LP4K 5 HRX 1LP4K 6
HRX 1LP4K 8
23/52