Rear Panel - Triax HMX 442 LP4K User Manual

2.3 Product Appearance of the HMX 884LP4K

2.3.2 Rear Panel

No. Name
① INPUTS
INPUTS
② OUTPUTS
③ RS232
④ IR ALL IN
⑤ TCP/IP
⑥ IR ALL OUT
Power
⑦
Button
⑧ Power
Supply
⑨ GROUND
(310037)
a. IR OUT: Plug the IR emitters in to the "IR OUT" 3.5mm jack sockets.
This allows the IR signals to be passed through the matrix to the re-
ceiver in the select zone or to all zones. The default setting enables
all corresponding inputs to be connected to their respective outputs,
i.e. IR IN 1 to be linked to IR OUT 1.
b. AUDIO: Auxiliary audio input ports, 8 in total, compatible with
PCM audio sources
c. HDMI: 8 x HDMI type A female sockets. Plug an HDMI cable in to the
socket and repeat on the Source device (such as Blu-ray)
d. IR IN: The matrix has 8 "IR IN" 3.5mm sockets. These connect
directly to the IR IN on the receivers. This forms a fixed bi-directional
transmission link.
e. RS232: The matric has 8 x 3-pin pluggable terminal blocks, these
enable fixed communication link with the RS232 port on
corresponding HDBaseT™ receiver.
f. AUDIO: 8 x stereo audio outputs
HDMI Type A connectors, plug an HDMI cable into
g. HDMI:
the output socket and connect it to either a local display or
AVR
.
h. HDBaseT: Uses HDBT technology to convert HDMI signals to
CAT5e/6
Serial port for unit control, 9-pin female connector, enables control of 3rd
party device such as a PC.
Plug an IR Receiver in to the "IR ALL IN" 3.5mm jack socket. Sends IR
command signals from the matrix to the receivers.
TCP/IP port for unit control
Receivers IR command signals from the receivers and re-transmits
the command signals to 3rd party devices such as AVR's.
Front panel Illuminate Green when powered on and RED in Standby. RED
Power on Indicator on rear panel
Plug the power supply in to the Matrix, select to correct power cord for
your region.
Ensure the Matrix is earth bonded.
12
Description
13/52