Related Manuals for Triax HMX 8x8V
Summary of Contents for Triax HMX 8x8V
- Page 1 HMX 8x8V Matrix Switch 8 x 8 Part No. 310003 Operating Manual TRIAX - your ultimate connection...
-
Page 2: Table Of Contents
The illustrations in this operation manual are for explanation and guidance purposes only. • The examples used throughout this manual are based on the HMX 8x8V model. Dear Triax customer Thank you for purchasing the TRIAX HMX 8x8 HDMI to CAT 6 Matrix Switch To ensure safety and many years of trouble-free operation, please read the Important Safety Precautions carefully before using this product. -
Page 3: Safety Precautions
Important Safety Precautions • Cleaning - Unplug the AC power from the mains supply before cleaning the product. Use a damp cloth to clean the product. Do not use liquid cleaners or aerosol cleaners. • Use a soft damp cloth to gently wipe the product when it is dirty. To protect the product, do not use a chemical cloth to clean it. -
Page 4: Introduction
Introduction The HMX 8X8V is an 8 by 8 HDMI Matrix switch that converts the HDMI source signals to CAT5e/6/7. With resolutions up to 1080p Full HD, 1920x1200@60Hz and multichannel digital audio supplied by up to eight High-definition sources to any of the eight CAT5e/6/7 outputs. It supports digital audio formats such as LPCM 7.1CH, Dolby TrueHD, Dolby Digital Plus and DTS-HD. -
Page 5: Features
Supports resolutions to VGA ~ WUXGA and 480i~1080p follow by output display’s EDID • Supports extension up to 100 meters through CAT5e/6/7 • Supports POE (Power Over Ethernet) TRIAX receivers only • Supports HDMI input up to 15 meters with 8bits resolution or 10 meters with 12bits resolution •... -
Page 6: Front Panel Overview
Lock button and LED: Press the “Lock” button to disable the buttons on the front panel, to activate them press the “Lock” button again. IR Sensor: The IR sensor only accepts commands from the HMX 8X8V Matrix’s RCU. The RCU is designed to configure the Matrix switch only. Menu: Press this button once to select EDID setting from STD (internal) 1 or TV (external) 2 then press it again to confirm the selection. Press this button every time to confirm and Save... -
Page 7: Rear Panel Overview
Rear Panel Overview Ethernet Connection point from Router allowing Internet RS-232 Used to connect PC, Laptop or notebook to the Matrix for programing, it requires a D-SUB 9 pin cable. (Not supplied). All IR output “IR Blaster” 3.5mm stereo jack socket, “IR” signals are blasted across all “Sources”. NOTE if more than 1 SKY Receiver is used a Directional “IR”... -
Page 8: Remote Control
Remote Control Standby Switches Matrix in to Standby Mode Hold down for 5 sec Input Selector Select 1-8 to choose required Source Output Selector Select A-H, selects required Source and routes to Sink / Room IR Cable Pin Assignment IR Blaster connection IR Extender Power 5V IR Signal... -
Page 9: Rs-232 Pin Assignment
RS-232 Pin Assignment Assignment Assignment Baud Rate: 19200bps Data Bit: 8 bits Parity: None Stop Bit: Flow Control: None RS-232 Commands Command (Case Sensitive) Description A1-A8 Switch output A to 1-8 B1-B8 Switch output B to 1-8 C1-C8 Switch output C to 1-8 D1-D8 Switch output D to 1-8 E1-E8... -
Page 10: Connection And Installation Example
Connection and Installation Diagram Specifications Max. TMDS bandwidth 6.75GBps 8 x HDMI, 9 x IR Extender, 1 x RS-232 Input Ports 1 x Mini USB B-type 9 (use for firmware upgrades only) Output Ports 8 x CAT5e/6/7, 9 x IR Blaster Human Body Model: ±8kV (air gap discharge), ESD Protection ±4kV (contact discharge) -
Page 11: Acronyms
Acronyms Acronym Complete Term Digital Theatre System Digital Visual Interface EDID Extended Display Identification Data HDCP High-Bandwidth Digital Content Protection HDMI High-Definition Multimedia Interface HDTV High-Definition Television Liquid Crystal Display Universal Serial Bus UXGA Ultra Extended Graphics Array Video Graphics Array... - Page 12 Issue 2 *Triax reserves the right to change the specifications without prior notification...