Related Manuals for Triax HMX 4x4K
Summary of Contents for Triax HMX 4x4K
- Page 1 HMX 4x4K Matrix 4 x 4 Kit Part No. 310004 Operating Manual TRIAX - your ultimate connection...
-
Page 2: Table Of Contents
The examples used throughout this manual are based on the HMX 4x4K model. Dear Triax customer Thank you for purchasing the TRIAX HMX 4x4K HDMI to CAT 6 Matrix Switch To ensure safety and many years of trouble-free operation, please read the Important Safety Precautions carefully before using this product. -
Page 3: Safety Precautions
Important Safety Precautions • Cleaning - Unplug the AC power from the mains supply before cleaning the product. Use a damp cloth to clean the product. Do not use liquid cleaners or aerosol cleaners. • Use a soft damp cloth to gently wipe the product when it is dirty. To protect the product, do not use a chemical cloth to clean it. -
Page 4: Introduction
Introduction The HMX 4X4K is a 4 by 4 HDMI Matrix switch that converts the HDMI source signals to CAT5e/6/7. With resolutions up to 1080p Full HD, 1920x1200@60Hz and multichannel digital audio supplied by up to four High-definition sources to any of the four CAT5e/6/7 outputs. It supports digital audio formats such as LPCM 7.1CH, Dolby TrueHD, Dolby Digital Plus and DTS-HD. -
Page 5: Features
Supports resolutions to VGA ~ WUXGA and 480i~1080p follow by output display’s EDID • Supports extension up to 100 meters through CAT5e/6/7 • Supports POE (Power On Ethernet) TRIAX receivers only • Supports HDMI input up to 15 meters with 8bits resolution or 10 meters with 12bits resolution •... -
Page 6: Front Panel Overview
Press the “Lock” button to disable the buttons on the front of the panel, to activate them Press and Hold the “Lock” button for 5 seconds. IR Sensor: The IR sensor only accepts commands from the HMX 4X4K Matrix’s RCU. The RCU is designed to configure the Matrix switch only. Menu: Press this button once to select EDID setting from STD (internal) 1 or TV (external) 2 then press it again to confirm the selection. Press this button every time to confirm and Save... -
Page 7: Rear Panel Overview
Rear Panel Overview 4 6 8 Ethernet Connection point from Router allowing Internet RS-232 Used to connect PC, Laptop or notebook to the Matrix for programing, it requires a D-SUB 9 pin cable. (Not supplied). All IR output “IR Emitter” 3.5mm stereo jack socket, “IR” signals are emitted across all “Sources”. NOTE if more than 1 SKY Receiver is used a Directional “IR”... -
Page 8: Remote Control
Remote Control Standby Switches Matrix in to Standby Mode Hold down for 5 sec Input Selector Select 1-4 to choose required Source Output Selector Select A-D, selects required Source and routes to Sink / Room IR Cable Pin Assignment IR Emitter connection IR Digital Eye Power 5V IR Signal... -
Page 9: Rs-232 Pin Assignment
RS-232 Pin Assignment Assignment Assignment Baud Rate: 19200bps Data Bit: 8 bits Parity: None Stop Bit: Flow Control: None RS-232 Commands Command (Case Sensitive) Description A1-A4 Switch output A to 1-4 B1-B4 Switch output B to 1-4 C1-C4 Switch output C to 1-4 D1-D4 Switch output D to 1-4 ABCD..1 - ABCD..4... -
Page 10: Connection And Installation Example
Connection and Installation Diagram Specifications Video bandwidth 225MHz/6.75GBps 4 x HDMI, 5 x IR Digital Eyes, 1 x RS-232 Input Ports 1 x Mini USB B-type 9 (use for firmware upgrades only) Output Ports 4 x CAT5e/6/7, 4 x IR Emitter Human Body Model: ±8kV (air gap discharge), ESD Protection ±4kV (contact discharge) -
Page 11: Acronyms
Acronyms Acronym Complete Term Digital Theatre System Digital Visual Interface EDID Extended Display Identification Data HDCP High-Bandwidth Digital Content Protection HDMI High-Definition Multimedia Interface HDTV High-Definition Television Liquid Crystal Display Universal Serial Bus UXGA Ultra Extended Graphics Array Video Graphics Array... - Page 12 Issue 2 *Triax reserves the right to change the specifications without prior notification...