Rs232 Communication Commands - Continued - Triax HMX 442 LP4K User Manual

Command
Clear[Y].
PWON.
PWOFF.
STANDBY.
Audio/[X]:[Y].
/%[Y]/[X]:[Z].
[x1]R[x2].
DigitAudioON[
x].
DigitAudioOF
F[x].
*Note: outputs depends on matrix model
Function
Clear the preset command [Y].
Work in normal mode.
Enter into standby mode and cut off the
power supply to HDBaseT receivers.
Enter into standby mode. (Do not cut off
the power supply to HDBaseT receivers,
press other buttons or send other
commands to start.)
Select HDMI audio or analogue audio
as audio source for output 1~8.
HDCP management command.
[Y] is for input (value: I) or output (value:
O); [X] is the number of the port, if the
value of X is ALL, it means all ports; [Z] is
for working status (value: 1 or 0).
Transfer the IR signal from input channel
[x1] to output channel [x2].
Enable HDMI audio output of port x.
 X=1, 2, 3, 4, 5, 6, 7, 8, enable this
port.
 X=9, enable all the 8 ports.
Disable HDMI audio output of port x.
 X=1, 2, 3, 4, 5, 6, 7, 8, disable this
port.
 X=9, disable all the 8 ports.
Feedback Example
Clear FY (Y=0-9)
PWON
PWOFF
STANDBY
Audio/[X]:[Y]. X=1~8,
Y=0 (HDMI audio) or 1
(Analogue audio).
/%[Y]/[X]:[Z]. Y=I/
O;
X=1~8 or ALL; Z=1/0
IR: X1-> X2 (X1/
X2=1~8)
DigitAudio ON with [x]
x=1~8 or ALL
DigitAudio OFF with
[x]
x=1~8 or ALL
31/52