Assembly And Adjustment - Makita EY2650H Original Instruction Manual

ASSEMBLY AND ADJUSTMENT

WARNING:
• Before assembling, adjusting or checking, switch off the engine and remove the spark plug cap.
• Always wear protective gloves when handling saw chain.
• Wait until the saw chain cools down before assembling, adjusting or checking. The saw chain become very hot during the operation, and may
cause burn.
Assembling shaft and clutch case
Assemble the shaft with the rear grip and the engine unit as follows:
1. Insert the shaft through the rear grip (A).
2. Loosen two fastening bolts (B) and remove the center bolt (C) on the clutch
case.
3. Insert the shaft into the clutch case. If it is difficult to fully insert, turn the
spline (D) a little.
4. Align the hole on the shaft with the hole of the center bolt.
5. Tighten the center bolt.
6. Tighten two fastening bolts evenly.
7. Adjust the position of the rear grip, then tighten it by two bolts (E).
Assembling shaft and gear case
Assemble the shaft with the gear case as follows:
1. Loosen the bolt (A). And remove the bolt (B).
2. Insert the shaft into the gear case. If it is difficult to fully insert it, turn the
spline (C) a little.
3. Align the hole on the shaft with the bolt (B) hole.
4. Tighten the bolt (B) first and then tighten the bolt (A).
11
A
C
B
E
C
B
A
D