Connect Gas Supply - Southbend P36N-TTT Owner's Manual

W ' G R
ENDY S AS ANGE
Step 5: Connect Gas Supply
Installation of the range must conform with local codes related to the location of the installation, or in
the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1, Natural Gas Installation
Code, CAN/CGA-B149.1, or the Propane Installation Code CAN/CGA-B149.2, latest editions, as
applicable.
The appliance and its individual shutoff valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressures in excess of 1/2 psi (3.45 kPa).
A 1" NPT female line is provided at the rear for the gas connection.
If this equipment is being installed at over 2,000 feet altitude and that information was not specified when
ordered, contact the appropriate authorized Southbend Service Representative or Southbend Technical
Service. Failure to install with proper orifice sizing will result in poor performance and may void the
warranty.
A serial plate is located inside the front lower panel. It indicates the type of gas the unit is equipped to burn.
All Southbend equipment is adjusted at the factory. Check type of gas on serial plate.
This appliance should be connected ONLY to the type of gas for which it is equipped. The inlet pressure
before the regulator should be 7-10" (178-254mm) W.C. for natural gas or 11-14" (279-356mm) W.C. for LP
gas.
An adequate gas supply is imperative. Undersized or low pressure lines will restrict the volume of gas
required for satisfactory performance. An adequate gas supply line to the unit should be no smaller than
the I.D. of the pipe from the unit to which it is connected.
Purge the supply line to clean out dust, dirt, or other foreign matter before connecting the line to the unit.
INSTALLATION AND SERVICE WORK MAY BE PERFORMED ONLY BY A QUALIFIED
TECHNICIAN WHO IS EXPERIENCED IN, AND KNOWLEDGEABLE WITH, THE OPERATION OF
COMMERCIAL COOKING EQUIPMENT.
BEFORE PROCEEDING VERIFY THAT ANY ELECTRIC POWER TO THE UNIT HAS BEEN SHUT
OFF.
If installing the optional flex hose. the flex-hose installation instructions, along with local and national
codes, supersede any implied assembly instructions of its components illustrated in this document
For an appliance equipped with casters, (1) the installation shall be made with a connector that
complies with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors
for Moveable Gas Appliances, CAN/CGA-6.16, and a quick-disconnect device that complies with the
Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI Z21.41, or Quick Disconnect
Devices for Use with Gas Fuel, CAN1-6.9, (2) adequate means must be provided to limit the
movement of the appliance without depending on the connector and the quick-disconnect device or
its associated piping to limit the appliance movement and (3) the restraining means should be
attached to a frame member on the back of the unit.
Connect the gas supply to the unit. If installing the optional flex hose, follow the instructions supplied with
the flex-hose kit. The following picture shows one of several possible flex-hose installation configurations.
O '
WNER
IMPORTANT SAFETY INSTRUCTIONS
NOTICE
M 1195747
S ANUAL
WARNING
I
NSTALLATION
P
AGE
13