Installing/Replacing An Msam Card - VeriFone e335 Installation Manual

D S
EVICE ETUP

Installing/Replacing an MSAM Card

Installing/
Replacing an
MSAM Card
CAUTION
NOTE
To install/replace
MSAM
NOTE
14
335 I
E NSTALLATION
When you first receive your e335, you may need to install an MSAM card or you
may need to replace an old card.
Observe standard precautions when handling electrostatically sensitive devices.
Electrostatic discharges can damage this equipment. VeriFone recommends
using a grounded anti-static wrist strap.
Not all applications require the use of an MSAM card.
1
Loosen the retaining screw at the back of the SAM cover. The retaining screw
is captive, which means that it cannot be fully removed from the slot.
2
Pull out the cover to display the MSAM compartment.
3
Unlock the MSAM compartment by pulling the locking tab downwards.
4
Hook your finger under locking tab and lift up to swivel the MSAM tray open.
5
Place the MSAM card on top of the tray with the gold contacts facing down
and then gently push down the tray to close.
Make sure that the MSAM card sits firmly on the tray to be able to close the
MSAM compartment.
6
Push the locking tab upwards to lock the tray and secure the MSAM card.
7
Place the cover back and tighten the screw.
A
Figure 4 Inserting an MSAM card
G
UIDE
D
B C