Manually Starting And Shutting Down The E335; Connecting The E335 To A Power Source Or A Host Computer - VeriFone e335 Installation Manual

D S
EVICE ETUP

Manually Starting and Shutting Down the e335

To remove the iPad
mini from the e335
' ,
*
Manually
Starting and
Shutting Down
the e335
NOTE
Connecting the
e335 to a Power
Source or a Host
Computer
NOTE
16
335 I
E NSTALLATION
1
Loosen the retaining screw at the back of the e335.
2
Slide the release button downward to disengage the casing and the iPad mini
from the main unit.
3
Remove the iPad mini from the casing.
4
Hold and secure the e335 with the PIN pad facing down.
5
Return the e335 casing and then tighten the screw at the back.
A
B
C
Figure 6 Removing an iPad mini from the e335
Press the Home button on the iPad mini to automatically turn on the e335.
Similarly, the e335 automatically turns off when the iPad mini is inactive.
•
To reset or manually turn the e335 on, place a paper clip or a similar tool in
the hole located at the bottom of the e335 to press the reset button.
•
Press the Cancel key for at least three seconds to manually shut down the
e335.
Plug the wall-mount charger to an external power source and connect it to the
e335 to charge the device. You can also connect the e335 to a computer to
synchronize data and/or charge the device.
•
To optimize the charging time, use only a VeriFone certified wall-mount
charger (VPN PWR087-300-01-A)
•
Fully charge the e335 device before initial use.
•
The e335 device must be fully charged before USB power can be used to
charge the iPad mini.
G
UIDE
' ,
*
D
E