Display Instruction - KStar YDC9300-0.8 User Manual

1.5.3 Display instruction

1) The main interface below comes out when the power is connected or the system is in
cold start. See Fig1
YDC9310
10KVA
Fig.1：Main interface
2) Press any key, it will change to the basic status interface , see Fig2 below
MODE:On-Line
Volt:AN BN CN
Vin: 220 219 221
Vout:220
Fig.2：Basic status interface
Press the ◀ or ▶
3)
FIGURE
STATUS
SETTING
COMMAND
Fig.3： Main menu
4) An arrow icon will come out on the LCD when pressing the ENT, then, the data info,
status info, setting info, command control can be selected by pressing the right or left
arrow button, and checking the details by pressing
5) Select and confirm the data info to be viewed in detail. It contains the details of the
AC input /output , inverter, battery , BUS, parallel , temperature. See Fig 4～Fig 12
below.
Figure
Mains
A:225.9 B:224.8
C:225.5
Fig.4：MAIN INPUT INFO
button, it will change to main menu, see Fig3，
Figure
Output
220.0V
50.0HZ Load: 0%
Fig.5：OUTPUT INFO
- 11 -
Figure
Output
0.0A 0KW
0KVA
Fig.6：OUTPUT INFO
PAK: 0