Lcd Display Instruction - KStar YDC9300-RT Series Manual

After setting the parallel amount, press ESC and return to the "setting" menu; then press forward
button or backward button to choose "system set" and press ENT to enter it. The system setting
menu is as Fig.8; Then ppress ENT to enter "mode" setting as Fig.9. Use the forward button or
backward button to set the mode, choose "parallel" and press ENT to save this setting.
Setting
System Set
Mode On-Line
Power Enable
Fig.8：system setting
Note:
After setting all the parallel UPS, power off all the UPS, and press "UPS Multi－
Module Installation" to connect the UPS, then turn on the UPS.

4.3 LCD Display instruction

1） The main interface below comes out when the power is connected or the system is in cold
start. See Fig1
Welcome
10KVA
Fig.1：main interface
2） Press any key, it will change to the basic status interface , see Fig2 below
Mode:On-Line
Volt:AN BN CN
Vin: 220 219 221
Vout:220
Fig.2：basic status interface
3） Press the or
Figure
Status
Setting
Command
Fig.3：main menu
Setting
System Set
Mode Parallel
Power Enable
Fig.9：system setting
button, it will change to main menu, see Fig3
- 17 -