KStar YDC9300-0.8 User Manual page 22

3) Connect the UPS output L, N, E to L, N, E of load via a PDU. Tighten the screws
and shelter the terminals
WARNING
Please connect the output Earth well before other operation

Connection of the UPS communication cables
1) RS-232 cable provided in accessories can be used to connect the UPS with PC
2) Follow step below is to install SNMP (if purchased )：
A. Remove the cover of SNMP slot at UPS rear panel and keep it for further use.
B. Insert the SNMP card and tighten the screws
C. Connect the UPS with internet by network cable.
D. Refer to the SNMP manual provided to do SNMP setting
！
- 22 -