Connecting To A Peripheral Device - Star Micronics FVP-10U Hardware Manual

3-7. Connecting to a Peripheral Device
You can connect a peripheral device to the printer using a modular plug.
Follow the instructions given below. For details about the recommended type of modular plug, see chapter 17, "Peripheral
Drive Circuit".
When using the Ethernet interface, to protect the printer from electromagnetic interference, affix the ferrite core that came with the
optional Ethernet interface board to the cable according to the instructions given below.
(1) Make sure that the AC adapter's power cable plug is not connected to the outlet.
(2) Affix the ferrite core to the peripheral drive cable as shown in the figure.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the peripheral drive cable, and lock it.
Use scissors to cut the excess part of the fastener.
6 cm (maximum)
(5) Connect the end of the cable with the ferrite core to the peripheral drive connector on the rear panel of the printer.
Connect the other end of the cable to the modular jack of the peripheral device.
CAUTION
Do not connect a telephone line into the peripheral drive connector. Failure to observe this may result in damage
to the printer.
Also, for safety purposes, do not connect wiring to the external drive connector if there is a chance it may carry
peripheral voltage.
Ferrite core
- 13 -
Peripheral drive cable
Pull and cut