Table of Contents
Advertisement
Command Line Interface
DHCP Relay Agent
IP Packet Processing
A-10
dhcp server nameserver ip-address
Specifies the DNS IP address used by the DHCP server.
Minimum access level: Administrator/Config
Example: dhcp server nameserver 132.53.4.2
dhcp relay {enable | disable }
Enables or disables the DHCP relay agent. The DHCP relay agent will maintain up to
256 DHCP clients.
Minimum level access: Administrator/Config
enable – Enable the DHCP relay. Default = enable.
disable – Disable the DHCP relay.
Example: dhcp relay enable
dhcp relay address ip-address
Use this command to specify the DHCP server to forward DHCP requests to.
Minimum level access: Administrator/Config
Example: dhcp relay address 132.23.4.2
IP multicast {enable | disable }
Enables or disables the forwarding of IP multicast packets. This setting is retained
across power cycles.
Minimum access level: Administrator
enable – Enable forwarding of IP multicast packets.
disable – Disable forwarding of IP multicast packets. Default = disable.
IP processing { enable | disable}
Enables or disables the processing of IP packets in the service domain. This setting is
retained across power cycles.
Minimum access level: Administrator
enable – Enable processing of IP packets. Default = enable.
disable – Disable processing of IP packets.
March 2000
6371-A2-GB20-00
Advertisement
Table of Contents
