Arp Table; Proxy Arp - Paradyne Hotwire 6321/6322 IDSL Router User Manual

Command Line Interface

ARP Table

Proxy ARP

A-6
arp timeout incomplete time
Specifies the ARP table timeout value in seconds for incomplete ARP table entries.
Default = 5 seconds.
Minimum access level: Administrator/Config
arp timeout complete time
Specifies the ARP table timeout value in minutes for complete ARP table entries.
Default = 20 minutes.
Minimum access level: Administrator/Config
arp { create | delete } ip-address mac-address
Creates or deletes a single, static ARP table entry. Static ARP entries created with this
command are retained across resets/power cycles.
Minimum access level: Administrator/Config
create – Create an ARP table entry.
delete – Delete an ARP table entry.
ip-address – The IP address of the ARP entry to be created or deleted.
mac-address – MAC address (valid for create command).
Examples:
arp create 132.53.4.2
arp delete 132.53.4.2
arp purge ALL
Deletes ALL static and dynamic ARP table entries.
Minimum access level: Administrator/Config
proxy arp { e0 | d0 } [ enable | disable ]
Enables or disables proxy ARP for the specified interface. If enable/disable is not
specified in the command, enable is the default.
Minimum access level: Administrator/Config
e0 – The Ethernet interface.
d0 – The DSL interface.
enable – Enable Proxy ARP.
disable – Disable Proxy ARP.
NOTE: Proxy ARP and NAPT cannot be enabled at the same time. When Basic
NAT is enabled, Proxy ARP is allowed on the d0 interface.
Example: proxy arp d0 disable
March 2000 6371-A2-GB20-00