Paradyne Hotwire 6381 Upgrade Instructions

Adsl/r bridge/router boot code

Hide thumbs Also See for Hotwire 6381:

Hotwire ADSL/R Bridge/Router, Model 6381

Boot Code Upgrade Instructions

Document Number 6381-A2-GK40-00

September 2003

Installation Procedure

Use this procedure if the serial number of your ADSL/R router is below 5774747.

The serial number is located on the bottom of the router. If the serial number is

5774747 or above, you do not need to execute the boot code upgrade.

This procedure requires Microsoft Windows.

1. Verify that your router is powered on and connected to your PC.

2. Load the upgrade CD into the CD-ROM drive of your PC.

3. The upgrade should start automatically. If it does start automatically, skip

to Step 4. If it does not start automatically:

In Windows, click on the Start icon, then select Run. The Run

window appears.

Click on Browse. The Browse window appears.

Select bootupgr and click on Open.

In the Run window, click on OK to start the upgrade process.

Table of Contents

Do you have a question about the Hotwire 6381 and is the answer not in the manual?

Page 1: Installation Procedure
Use this procedure if the serial number of your ADSL/R router is below 5774747. The serial number is located on the bottom of the router. If the serial number is 5774747 or above, you do not need to execute the boot code upgrade.
Page 2 Paradyne 6381. This is the Telnet program, which is used to perform the upgrade. The Telnet window closes after a few moments. Your router is automatically rebooted to make the upgrade permanent. 5. Watch the light-emitting diode marked LINE on the faceplate of your router.