Table of Contents
Advertisement
6371-A2-GB20-00
ip route create upstream e0[/ifn] next-hop-ip
ip route delete upstream e0[/ifn]
Enter or delete upstream IP routing table entries. When the DSL interface is
unnumbered, an IP routing table entry will be created automatically with the next hop
router as remote.
Minimum access level: Administrator/Config
create – Create an IP route table entry.
delete – Delete an IP route table entry.
e0, e0/1, e0/2, e0/3, e0/4 – Ethernet interface. e0 is the same as e0/1. Specified logical
Ethernet interface.
next-hop-ip – IP address of the next hop upstream router used to reach the remote
destination.
NOTE:
When the DSL interface is configured for numbered mode, the next hop
router IP address must fall into one of the (service domain) IP subnets
configured for the DSL interface.
Example: Refer to Refer to Chapter 4,
ip route purge
Deletes all static and dynamic IP route table entries, including interface routes.
NOTE:
An interface route is created automatically when an address and mask are
assigned to an Ethernet interface with the ifn address command. The
Ethernet interface route can be deleted with the ip route purge or the
ip route delete command. Once deleted, the interface route must be
entered manually using ip route create or the ifn address
command.
Minimum access level: Administrator/Config
March 2000
Command Line Interface
DSL Router Configuration
Examples.
A-5
Advertisement
Table of Contents
