Show Command Outputs - Paradyne Hotwire 6321/6322 IDSL Router User Manual

Show Command Outputs

6371-A2-GB20-00
show console
console enabled or console disabled
Displays:
show system
Sample show system display:
Jul 21 09:53:26 1999
System ID: xxxxxxxx
Model #: xxxx, Serial #: xxxxxxxxxxxx, HW-Rev: xxx
Boot: FW-Version: xxxxxxxx
2nd Stage Boot: FW-Version: xxxxxxxx
Image 0: FW-Version: xxxxxxxx, [active]
Image 1: FW-Version: xxxxxxxx
DSL: FW-Version: xxx
Selftest Result: { pass | failed }
show config
Sample show config display:
syslog – { enabled | disabled }
e0 frame – { DIX | 802.3 }
proxy ARP e0 – { enabled | disabled }
proxy ARP d0 – { enabled | disabled }
NAT disabled or NAT enabled – { basic NAT | NAPT }
DHCP server – { enabled | disabled }
DHCP relay – { enabled | disabled }
IP multicast – { enabled | disabled }
IP processing – { enabled | disabled }
show ip route [ ip-address ]
If an IP address is not provided, the entire table will be displayed with the upstream
routes displayed first and the downstream routes next. If the IP address is provided, only
the specific entry will be displayed. If the next hop IP address = 0.0.0.0, the host is
directly reachable on the Ethernet interface (e0).
Minimum access level: Operator
Sample show ip route display:
source ip-addr source subnet-mask
x.x.x.x x.x.x.x
dest ip-addr dest subnet-mask
x.x.x.x x.x.x.x
March 2000
Command Line Interface
nexthop ip-addr interface
x.x.x.x d0
nexthop ip-addr interface
x.x.x.x e0
A-11