Rebuilding A Raid Set - Asus Motherboard NCLV-D2 Series Product Manual

5.5.9 5.5.9 5.5.9

Rebuilding a RAID set

Rebuilding a RAID set Rebuilding a RAID set
5.5.9 5.5.9 Rebuilding a RAID set Rebuilding a RAID set
The utility displays the condition of the RAID set during the POST. When a
RAID set is degraded, you can use the utility to rebuild it.
•
•
•
There are two ways to rebuild a RAID set: system shutdown rebuild and
manual rebuild. Refer to the sections below for details.
System shutdown rebuild System shutdown rebuild System shutdown rebuild System shutdown rebuild System shutdown rebuild
When a RAID set drive fails or an array gets degraded, shut down the
system and replace the failed drive with a new one (of equal or greater
capacity). When you reboot the system, you can assign the new drive as a
spare, and automatically start the rebuild process. The existing drive data
is copied to the new one, and the original RAID 1 array is recreated.
Manual rebuild Manual rebuild Manual rebuild Manual rebuild Manual rebuild
To manually rebuild a RAID set:
1. Select M a n a g e A r r a y s M a n a g e A r r a y s from the Main Menu, then press <Enter> to M a n a g e A r r a y s M a n a g e A r r a y s M a n a g e A r r a y s
display the list of arrays.
5 - 6 4 5 - 6 4
5 - 6 4 5 - 6 4 5 - 6 4
You may only rebuild Fault Tolerant arrays (RAID 1).
If no spare exists and a hard disk drive fails, you need to create a
spare before you can rebuild an array.
By replacing a failed drive of a RAID 1 array with a new drive, you
can rebuild to get the array to optimal status and assume fault
tolerance.
C h a p t e r 5 : R A I D c o n f i g u r a t i o n C h a p t e r 5 : R A I D c o n f i g u r a t i o n
C h a p t e r 5 : R A I D c o n f i g u r a t i o n C h a p t e r 5 : R A I D c o n f i g u r a t i o n C h a p t e r 5 : R A I D c o n f i g u r a t i o n