5.5.1
5.5.1
5.5.1
Configuring the hard disk drive(s)
Configuring the hard disk drive(s)
Configuring the hard disk drive(s)
5.5.1
5.5.1
Configuring the hard disk drive(s)
Configuring the hard disk drive(s)
You must configure the drive(s) that you want to include in an array.
To configure the drive(s):
1.
From the Adaptec RAID Configuration Utility initial menu, highlight
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y, then press <Enter>.
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
2.
From the Main Menu, select C o n f i g u r e D r i v e s
3.
Select the drive(s) that you want to configure, then press <Insert>.
The selected drive appears in the S e l e c t e d D r i v e s
the process to select other drives, then press <Enter>.
4.
A warning message appears on screen. Press <Y> to configure the
selected drives, or press <N> to abort.
A S U S N C L V - D 2 S e r i e s
A S U S N C L V - D 2 S e r i e s
A S U S N C L V - D 2 S e r i e s
A S U S N C L V - D 2 S e r i e s
A S U S N C L V - D 2 S e r i e s
C o n f i g u r e D r i v e s
C o n f i g u r e D r i v e s, then press <Enter>.
C o n f i g u r e D r i v e s
C o n f i g u r e D r i v e s
S e l e c t e d D r i v e s section. Repeat
S e l e c t e d D r i v e s
S e l e c t e d D r i v e s
S e l e c t e d D r i v e s
5 - 4 9
5 - 4 9
5 - 4 9
5 - 4 9
5 - 4 9