Table of Contents
Advertisement
5.1.4
5.1.4
5.1.4
RAID configuration utilities
RAID configuration utilities
RAID configuration utilities
5.1.4
5.1.4
RAID configuration utilities
RAID configuration utilities
Depending on the RAID connectors that you use, you can create a RAID set
using the utilities embedded in each RAID controller. For example, use the
L S I L o g i c E m b e d d e d S A T A R A I D S e t u p U t i l i t y
L S I L o g i c E m b e d d e d S A T A R A I D S e t u p U t i l i t y
L S I L o g i c E m b e d d e d S A T A R A I D S e t u p U t i l i t y
L S I L o g i c E m b e d d e d S A T A R A I D S e t u p U t i l i t y if you installed
L S I L o g i c E m b e d d e d S A T A R A I D S e t u p U t i l i t y
SATA hard disk drives on the SATA connectors supported by the Intel
6300ESB Southbridge and/or the A d a p t e c S C S I S e l e c t ( T M ) U t i l i t y !
you installed SCSI hard disk drives to the SCSI connector supported by the
Adaptec
®
AIC-7901X RAID controller (NCLV-DS2 model only). Refer to the
succeeding sections for details on how to use each RAID configuration
utility.
If you want to boot the system from a hard disk drive included in a
created RAID set, copy first the RAID driver from the support CD to a
floppy disk before you install an operating system to the selected hard
disk drive. Refer to Chapter 6 for details.
A S U S N C L V - D 2 S e r i e s
A S U S N C L V - D 2 S e r i e s
A S U S N C L V - D 2 S e r i e s
A S U S N C L V - D 2 S e r i e s
A S U S N C L V - D 2 S e r i e s
A d a p t e c S C S I S e l e c t ( T M ) U t i l i t y !
A d a p t e c S C S I S e l e c t ( T M ) U t i l i t y ! if
A d a p t e c S C S I S e l e c t ( T M ) U t i l i t y !
A d a p t e c S C S I S e l e c t ( T M ) U t i l i t y !
®
5 - 3
5 - 3
5 - 3
5 - 3
5 - 3
Advertisement
Table of Contents
