Table of Contents
Advertisement
(NCLV-D2/SATA model only)
The Adaptec RAID Configuration Utility allows you to create RAID 0, RAID 1,
and RAID 10 set(s) from SATA hard disk drives connected to the SATA
connectors supported by the Adaptec
To enter the Adaptec RAID Configuration Utility:
1.
Turn on the system after installing all the SATA hard disk drives.
2.
During POST, the Adaptec HostRAID™ technology automatically
detects the installed SATA hard disk drives and displays any existing
RAID set(s). Press <Ctrl> + <A> to enter the utility.
3.
Use the arrow keys to highlight an option.
The A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y
A r r a y C o n f i g u r a t i o n U t i l i t y menu lets you create and
A r r a y C o n f i g u r a t i o n U t i l i t y
manage RAID sets. The D i s k U t i l i t i e s
check the consistency of the hard disk drives.
At the bottom of the screen is the legend box. The keys on the
legend box allow you to navigate through the setup menu options or
execute commands. The keys on the legend box vary according to the
menu level.
5 - 4 8
5 - 4 8
5 - 4 8
5 - 4 8
5 - 4 8
®
®
SATA RAID controller.
D i s k U t i l i t i e s
D i s k U t i l i t i e s
D i s k U t i l i t i e s allows you to format and/or
D i s k U t i l i t i e s
C h a p t e r 5 : R A I D c o n f i g u r a t i o n
C h a p t e r 5 : R A I D c o n f i g u r a t i o n
C h a p t e r 5 : R A I D c o n f i g u r a t i o n
C h a p t e r 5 : R A I D c o n f i g u r a t i o n
C h a p t e r 5 : R A I D c o n f i g u r a t i o n
Advertisement
Table of Contents
