Table of Contents
Advertisement
Command Line Interface (CLI)
Name
Server IP Address or
Name
Port (optional)
Shared Secret
Response Time (sec)
Maximum
Retransmissions
(optional)
Rogue Access Point Detection (RAD) Parameters
Name
Rogue Access Point Detection (RAD) Group
Status
Scan Interval
Interface Bitmask
VLAN/SSID Parameters
Name
VLAN
Status
Management ID
VLAN ID Table
NOTE �
16 VLAN/SSID pairs are available for APs with an HP ProCurve Wireless 802.11g AP Card 170wl only.
Name
VLAN ID Table
1
Index
Identifier (ID)
Network Name (SSID)
Status
Note 1: When adding a new entry to the table, you must specify the index instance you want to configure, such as 3.5;
the 0 index value is not applicable to this table and does not create a new entry.
Type
Values
IpAddress
User Defined
Display String
(enter an IP address if
seraddrfmt is ipaddr or a
name if set to name; up
to 254 characters if
using a name)
Integer
User Defined
1813 (default)
DisplayString
User Defined
max 63 characters
Integer
1 – 4 seconds
3 sec (default)
Integer
1 – 10
3 (default)
Type
N/A
Integer
enable
disable (default)
Integer
15-1440 (minutes)
Interface
4 (WiF A), 8 (WiF B), or 12
Bitmask
(both).
Type
Group
N/A
Integer
enable
disable (default)
VlanId
-1 (untagged)
or 1-4094
Type
Table
N/A
Integer32
3.1 - 3.16 (Wireless A);
4.1 - 4.16 (Wireless B; Dual-radio APs only)
VlanId
-1 or 0 (both correspond to untagged)
or 1-4094
DisplayString
2-31 characters
Integer
enable (default when new entry created)
disable
delete
Access
CLI Parameter
RW
ipaddr
RW
port
W
ssecret
RW
responsetm
RW
maxretx
Values
Access
R
RW
RW
RW
Values
Access
R
RW
RW
Values
Access
R
R
RW
RW
RW
CLI Parameter
rad
radstatus
radscanint
radifbitmask
CLI Parameter
vlan
vlanstatus
vlanmgmtid
CLI Parameter
vlanidtbl
index
id
ssid
status
C-44
Advertisement
Table of Contents
