Auto Configuration Parameters; Tftp Server Parameters - HP ProCurve 520wl User Manual

Command Line Interface (CLI)

Auto Configuration Parameters

These parameters relate to the Auto Configuration feature which allows an AP to be automatically configured by
downloading a specific configuration file from a TFTP server during the boot up process.
Name
Auto Configuration
Auto Configuration
Status
Auto Config File Name
Auto Config TFTP
Server IP Address

TFTP Server Parameters

These parameters relate to upload and download commands.
When a user executes an upload and/or download command, the specified arguments are stored in TFTP parameters
for future use. If nothing is specified in the command line when issuing subsequent upload and/or download
commands, the stored arguments are used.
Name
TFTP
TFTP Server IP Address IpAddress
TFTP File Name
TFTP File Type
IP Access Table Parameters
When creating table entries, you may either specify the argument name followed by argument value or simply entering
the argument value. When only the argument value is specified, then enter the values in the order depicted by the
following table. CLI applies default values to the omitted arguments. Due to the nature of the information, the only
argument that can be omitted is the "comment" argument.
Name
IP Access Table
Table Index
IP Address
IP Mask
Comment (optional)
Status (optional)
Type Values
Group N/A
Integer enable (default)
disable
DisplayString User Defined
IpAddress User Defined
Type Values
Group N/A
User Defined
DisplayString User Defined
Integer img
config
bootloader
Type Values
Table N/A
Integer User Defined
IpAddress User Defined
IpAddress User Defined
DisplayString User Defined
Integer enable (default)
disable
delete
Access CLI Parameter
R autoconfig
RW autoconfigstatus
RW autoconfigfilename
RW autoconfigTFTPaddr
Access CLI Parameter
R tftp
RW tftpipaddr
RW tftpfilename
RW tftpfiletype
Access CLI Parameter
R mgmtipaccesstbl
N/A index
RW ipaddr
RW ipmask
RW cmt
RW status
C-35