HP ProCurve 520wl User Manual page 166

Command Line Interface (CLI)
Interface Parameters
Wireless Interface Parameters
The wireless interface group parameter is wif. For Dual-radio APs, Slot A uses table index 3 and Slot B uses table
index 4.
Common Parameters to 802.11a, 802.11b, and 802.11b/g APs
Name
Wireless Interfaces
Table Index
Network Name
Auto Channel Select (ACS)
DTIM Period
RTS/CTS Medium Reservation
MAC Address
Closed System
Supported Frequency Channels
Load Balancing
Note 1: For 802.11a APs in Europe, Auto Channel Select is a read-only parameter; it is always enabled.
802.11a Only Parameters
Name
Operating Frequency Channel
Supported Data Rates
Transmit Rate
Physical Layer Type
Type Values
Group N/A
Integer 3 (Slot A) or 4 (Slot B)
DisplayString 2 – 31 characters
My Wireless Network
(default)
1
Integer enable (default)
disable
Integer 1 – 255
1 = default
Integer 0 – 2347
Default is 2347 (off)
PhyAddress 12 hex digits
Integer enable
disable (default)
Octet String Depends on Regulatory
Domain
Integer enable (default)
disable
Type Values
Integer Varies by regulatory
domain and country. See
802.11a Channel
Frequencies
Octet String See Transmit
below
Integer32 0 - Auto Fallback
(default)
6 Mbits/sec
9 Mbits/sec
12 Mbits/sec
18 Mbits/sec
24 Mbits/sec
36 Mbits/sec
48 Mbits/sec
54 Mbits/sec
Integer ofdm (orthogonal
frequency division
multiplexing) for 802.11a
Access CLI Parameter
R wif
R index
RW netname
RW autochannel
RW dtimperiod
RW medres
R macaddr
RW closedsys
R suppchannels
RW ldbalance
Access CLI Parameter
RW channel
Rate, R suppdatarates
RW txrate
R phytype
C-30