HP ProCurve 520wl User Manual page 174

Command Line Interface (CLI)
Port Number
Protocol Name
Interface Bitmask
Status (optional)
Alarms Parameters
SNMP Table Host Table Parameters
When creating table entries, you may either specifying the argument name followed by argument value. CLI applies
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is
the "comment" argument.
Name
SNMP Trap Host Table
Table Index
IP Address
Password
Comment (optional)
Status (optional)
Syslog Parameters
The following parameters configure the Syslog settings.
Name
Syslog
Syslog Status
Syslog Port
Octet String User Defined
(there are also 4
pre-defined protocols:
Index 1: NetBios Name
Service – 137, Index 2:
NetBios Datagram
Service – 138, Index 3:
NetBios Session
Service – 139, Index 4:
SNMP Service – 161)
DisplayString User Defined
(there are also 4
pre-defined protocols,
see Port Number
Integer32 0 or 2 - no interfaces
(disable)
1 or 3 - Ethernet
4 or 6 - Wireless A
8 or 10 - Wireless B
12 = Wireless A & B
13 or 15 - all interfaces
(default is 15)
Integer enable (default for new
entries)
disable (default for
pre-defined entries)
delete
Type Values
Table N/A
Integer User Defined
IpAddress User Defined
DisplayString User Defined (up to 64
characters)
DisplayString User Defined (up to 254
characters)
Integer enable (default)
disable
delete
Type Values
Group N/A
Integer enable
disable (default)
Octet String 514
RW portnum
RW protoname
above)
RW ifbitmask
RW status
Access CLI Parameter
R snmptraphosttbl
N/A index
RW ipaddr
W passwd
RW cmt
RW status
Access CLI
R syslog
RW syslogstatus
R syslogport
C-38