HP ProCurve 520wl User Manual page 167

Command Line Interface (CLI)
802.11b Only Parameters
Name
Distance between APs
Interference Robustness
Operating Frequency Channel
Multicast Rate
Closed Wireless System
Medium Distribution
MAC Address
Supported Data Rates
Transmit Rate
Supported Frequency Channels
Physical Layer Type
Regulatory Domain List
NOTE �
There is an inter-dependent relationship between the Distance between APs and the Multicast Rate. In
general, larger systems operate a lower average transmit rates.
Distance between APs
Large
Medium
Small
Minicell
Microcell
Type Values
Integer large (default)
medium
small
minicell
microcell
Integer enable (default)
disable
Integer 1 - 14; available channels
vary by regulatory
domain/country; see
802.11b Channel
Frequencies
Integer 1 Mbits/sec (1)
2 Mbits/sec (2) (default)
5.5 Mbits/sec (3)
11 Mbits/sec (4)
Integer enable
disable (default)
Integer enable (default)
disable
PhyAddress 12 hex digits
Octet String 1 Mbits/sec
2 Mbits/sec
5.5 Mbits/sec
11 Mbits/sec
Integer32 0 (auto fallback - default)
1 Mbits/sec
2 Mbits/sec
5.5 Mbits/sec
11 Mbits/sec
Octet String Depends on Regulatory
Domain
Integer dsss (direct sequence
spread spectrum) for
802.11b
DisplayString U.S./Canada -- FCC
Europe -- ETSI
Japan -- MKK
Multicast Rate�
1 and 2 Mbits/sec
1, 2, and 5.5 Mbits/sec
1, 2, 5.5 and 11 Mbits/sec
1, 2, 5.5 and 11 Mbits/sec
1, 2, 5.5 and 11 Mbits/sec
Access CLI Parameter
RW distaps
RW interrobust
RW channel
RW multrate
RW closedsys
RW meddendistrib
R macaddr
R suppdatarates
RW txrate
R suppchannels
R phytype
R regdomain
C-31