Table of Contents
Advertisement
Installing the Convenience Base
with the Lower Anchor Connector
Assembly
WARNING
• This lower anchor connector assembly is intended
to be used
ONLY
as described in these instructions.
Serious injury or death may result from misuse.
• In addition to these instructions, read and follow your
vehicle owner's manual regarding installation of the
child restraint and LATCH. If there is a discrepancy,
follow your vehicle owner's manual.
•
ONLY
use for securing convenience base to vehicle
lower anchor bars.
•
NEVER
attach two lower anchor assembly connectors
to one vehicle lower anchor bar.
•
NEVER
use the vehicle seat belts when using the lower
anchor connector assembly. Using both together can
cause slack in a sudden stop or crash.
• When not in use, the lower anchor connector assembly
connectors should be securely stored in the storage
area located in the convenience base (see page 40).
Keep out of reach of children.
•
ALWAYS
be sure that the lower anchor connector
assembly connectors are fully engaged onto the vehicle
lower anchor bars by pulling hard on the lower anchor
connector assembly harness. If they are not totally
engaged, the lower anchor connector assembly system
will not secure your child restraint. Serious injury or
death may result.
•
DO NOT
use this child restraint if it moves more than
25 mm (1 inch) side-to-side or front to back at the
vehicle belt path. Serious injury or death may result
from poor installation. If you can not tightly secure
the child restraint, try again or move it to another
location.
• This child restraint
MUST
MUST
• The carrier
be locked firmly into the base.
Check by lifting up on the carrier.
•
NEVER
use this child restraint in the forward-facing
position.
face the rear of the vehicle.
20
1
Before you begin, be sure the
vehicle is on a level surface.
Place the base
and check the level indicator
A
C
D
The base is level when only
green (no red) is showing in
the level indicator window
IMPORTANT
Not all models are equipped with an adjustment foot. If
your model does not have one, use a rolled-up towel to
adjust base level (p. 26).
2
Route lower anchor connector assembly harness
and hook through lower anchor connector assembly
openings
on the sides of the base.
A
on the vehicle seat
A
.
B
B
If the indicator is red,
adjust the level of the base
by pressing adjustment
button
and lowering
C
the adjustment foot
D
Note: The adjustment foot
has multiple levels.
T
!
T
!
IP
IP
A green
filled window means
go to Step 2.
.
B
A
21
.
Hide quick links:
Advertisement
Table of Contents
