Installing Convenience Base With Vehicle Seat Belt - Evenflo Embrace 35 Owner's Manual

Know Your Lower Anchor
3
Connector Assembly
The lower anchor connector assembly that comes with
your child restraint will be one of the types below.
SecureRight
Adjuster
Hook
Strap
J
J
Refer to your vehicle owner's manual to locate the lower
anchor bars on your vehicle seat. Attach the right hook
J
, or clip , to the right anchor bar
K L
hook, or clip, to the left anchor bar.
the lower anchor connector hook, or clip, is fully engaged
by pulling hard on the lower anchor connector strap.
4
5
A
E
D
or front to back the harness is not tight enough. You
will need to try again, or find another location for your
convenience base.
IMPORTANT
Route any excess lower anchor connector assembly
harness strap through the openings
the base, so it does not interfere with the metal carrier
retainers when attaching the carrier.
E
Quick Connector
Strap
Clip
Adjuster
K
J
and the left
J
DOUBLE CHECK
Using your full weight,
push the base firmly into
the vehicle seat, while
pulling up on the strap to
tighten.
WARNING
Make sure the lower
anchor connector
assembly harness is tight.
Grab the base at the areas
D , as shown. If you can
move the base more than
25 mm (1 inch) side-to-side
, on the sides of
A
22
Installing the Convenience Base
• The carrier
convenience base. Check by lifting up on the carrier.
• NEVER use this child restraint in the forward-facing
position.
• DO NOT
equipped with lap belts that only lock during a sudden
stop or crash (emergency locking retractor – ELR). You
must use a seating location with a locking seat belt.
L
Check your vehicle owner's manual to see if you have
lap belts with ELR's.
1
Before you begin, be sure the vehicle is
that
C
T !
T !
IP
IP
Not all models are equipped with an adjustment foot.
If your model does not have one, use a rolled-up towel to
adjust base level (p. 26).
with the Vehicle Seat Belt
WARNING
MUST be locked firmly into the
use this child restraint rear-facing in a vehicle
on a level surface.
Place the base
vehicle seat and check the
A
level indicator
If the indicator is red,
adjust the level of the base
by pressing adjustment
button
C
the adjustment foot
Note: The adjustment foot
D
has multiple levels.
The base is level when only green (no red) is
showing in the level indicator window.
IMPORTANT
23
on the
A
.
B
B
and lowering
.
D