Securing The Child In The Carrier - Evenflo Embrace 35 Owner's Manual

Canadian OR
5
U.S. Models
Position 1
B
Squeeze both handle releases
to either Position 1 (Canadian OR U.S. models) or
Position 4 (U.S. models ONLY) until it locks into place.
Note: When using Position 4, make sure there is at
least 38 mm (1.5 inches) of space between any part
of the carrier and the vehicle seat that is closest to
the child's head. If you need additional clearance,
place the handle in Position 1.
6
F
If the level line is not parallel to the vehicle floor,
A
use a tightly rolled towel or small blanket
the front edge of the child restraint to provide
enough recline for an infant's head to lie back
comfortably.
IMPORTANT: Infants may have difficulty breathing
when in a sitting position. Make sure they recline
enough for their head to lie back comfortably and
safely. Failure to properly recline the child restraint could
increase the child's risk of serious injury or death.
U.S. Models
ONLY
Position 4
B
and move the handle
B
A
beneath
F
32

Securing the Child in the Carrier

Place the baby into the carrier. Baby's bottom and back
should be flat against the seat. If there is a gap, baby
will not be comfortable.
1
2
IMPORTANT: The buckle strap should be snug against
the baby's crotch, but never under the baby's bottom.
Adjust the crotch strap if necessary (p. 38).
Slide each harness
strap over the child's
shoulders.
Insert the buckle tongues
into the buckle. Pull up
on the harness strap
to ensure the buckle
tongues are engaged.
33