Removing The Lower Anchor Connector Assembly; Using The Locking Clip - Evenflo Embrace 35 Owner's Manual

Removing the Lower Anchor
Connector Assembly
1
Tilt and slide the adjuster
to loosen the lower anchor
connector assembly.
Adjuster
The Lower Anchor Connector that comes with your
2
child restraint will be one of the types below.
C
D
E
To remove the hook ,
C
press the tab and
D
twist, then remove from
anchor .
E
H
To remove the clip
press the red release
button
I
clip from anchor
Press the adjuster release
button to loosen the lower
anchor connector assembly
Adjuster Release
Or
Button
F
G
E
To remove the clip
F
pull the red release
strap and remove clip
G
from anchor .
E
I
E
,
H
and remove
.
E
40
3
When the lower anchor connector assembly is not in
use, you MUST
the bottom of the base
Route the harness strap through the belt path on top of
the base then attach the hooks to the slots
each side of the storage area beneath the base.
A loose lower anchor assembly connector harness and
hook may injure your child.
To watch a video about installing a locking clip, go to
www.evenflo.com.
,
• Seat belts equipped with an emergency locking
retractor (ELR). Some ELR vehicle belts can be
switched so that they lock when tightened. It may
not be necessary to use a locking clip in these
situations.
Locking Clip
E
F
securely store it in the area provided in
.
E

Using the Locking Clip

Use the locking clip with:
• Lap/shoulder seat belt
combinations that have a
buckle tongue that slides
freely along the belt
without locking into
place; AND
Consult your vehicle
owner's manual before
installing the locking
clip.
41
F
located on
F