Evenflo Discovery 5 Owner's Manual
Evenflo Discovery 5 Owner's Manual

Evenflo Discovery 5 Owner's Manual

Rear-facing child restraint
Hide thumbs Also See for Discovery 5:

Advertisement

Para instrucciones en Español, llamar al: 1-800-233-5921
O O W W N N E E R R ' ' S S M M A A N N U U A A L L
Keep for future use.
Discovery
5
Rear-facing Child Restraint
Child Requirements
Weight: 5 to 22 lbs (2.3 to 10 kg)
Height: 19 to 29 inches (48 to 74 cm)
WARNING
To reduce the risk of
SERIOUS INJURY or
DEATH, read this owner's
manual prior to installing
and using this child
restraint.
25700256
2/08
© Evenflo Company, Inc., 2008

Advertisement

Table of Contents
loading

Summary of Contents for Evenflo Discovery 5

  • Page 1 Weight: 5 to 22 lbs (2.3 to 10 kg) Height: 19 to 29 inches (48 to 74 cm) WARNING To reduce the risk of SERIOUS INJURY or DEATH, read this owner’s manual prior to installing and using this child restraint. 25700256 2/08 © Evenflo Company, Inc., 2008...
  • Page 2: Table Of Contents

    • IMPORTANT • More children are killed every year as passen- This child restraint meets all the requirements of Federal gers in car crashes than by any other type of Motor Vehicle Safety Standard 213. No child restraint injury. To reduce the risk of SERIOUS INJURY or can guarantee absolute protection from injury in every DEATH, read this owner’s manual and your vehicle crash.
  • Page 3: Warnings

    • When not in use, the LATCH harness and hook should be restraint. Consult vehicle owner’s manual, try a different securely stored in the storage area located in the child seating location or call Evenflo at 1-800-233-5921. restraint base. Keep out of reach of children. Seat Belt Warnings •...
  • Page 4: Safe Practices

    Evenflo or described in these instructions to the child to Evenflo Company, Inc., 1801 Commerce Dr., Piqua, OH restraint. Items not tested with the child restraint could injure 45356 or call 1-800-233-5921.
  • Page 5: Know Your Vehicle

    Know Your Vehicle Your vehicle components may appear significantly different than pictured. Consult your vehicle Owner’s Manual to help identify your vehicle components. Front Seat Lap and Shoulder Belts Fold-down Armrest Consult your vehicle Owner’s Manual. Air Bag Do not place your child restraint by any Front Rear air bags.
  • Page 6: Using Your Discovery™ Child Carrier/Restraint

    Using Your Discovery™ WARNING Child Carrier/Restraint Child’s head MUST be at least 1 inch (25mm) below the top of the carrier. Child Requirements 1. Secure the child in the child carrier. Weight: 5 to 22 lbs (2.3 to 10 kg) •...
  • Page 7: Changing The Harness Position

    Changing the Harness Position As your child grows, you will need to change the harness strap position so that the harness straps are routed through the slots closest to the child’s shoulders.The shoulder harness straps should ALWAYS be as close as possible to, but NEVER above, the child’s shoulders.
  • Page 8: Changing The Crotch Strap Position

    Securing Your Child in the Changing the Crotch Strap Position Child Restraint As your child grows, you will need to change the crotch strap position so that it is in the slot closest to your child. The crotch strap should ALWAYS be as close as possible to, NEVER...
  • Page 9: Removing Your Child From The Child Restraint

    Installing and Using the Convenience Base • IMPORTANT • • Be sure that the release button of the vehicle seat belt does not contact a side or edge of the child restraint. This could cause the vehicle seat belt to accidently release.
  • Page 10: Releasing The Child Restraint From The Base

    IP IP You may rotate the handle to the farthest position behind the restraint for more room in small vehicles. WARNING Rotate the handle to the down position by pressing on the red handle triggers located on each side of the DO NOT use this child restraint if it moves more than child restraint.
  • Page 11: Installing The Convenience Base With The Latch

    Installing the Convenience Place the base on the Base with the LATCH vehicle. Route the LATCH harness LATCH is a new system for attaching the child restraint to and hook through the your vehicle seat. It is to be used in place of your vehicle’s LATCH harness openings seat belts, and can only be used in vehicles with LATCH and under the tabs...
  • Page 12: Removing The Latch System

    Installing the Child Restraint Removing the LATCH System without the Base After securing the infant, place the restraint into your Tilt and slide the adjuster to loosen. vehicle. Adjust the restraint so that the level line parallel with the vehicle floor. NOTE: Generally, the center rear seating position is the safest.
  • Page 13: Using The Locking Clip

    Using the Locking Clip LAP BELT LAP AND SHOULDER BELT Use the locking clip with lap/shoulder vehicle seat belts that have a free sliding buckle tongue. See pages 15 – 22 to install this child restraint and its base. Remove the locking clip from the slot on the bottom NOTE: In vehicles with a lap and shoulder belt and a...
  • Page 14: Using As An Infant Carrier

    Using as an Infant Carrier No more than Secure the child in the 1/2” (13 mm) carrier by following “Securing Your Child in the Child Restraint” on page 13. To use as a stand: Thread both straps of the seat belt onto the locking Rotate the handle completely clip, and slide into place.
  • Page 15: Canopy Installation

    Proper Disposal of this Child Restraint Note that the sku/part number will appear on a label on the At the end of this child restraint’s useful life, Evenflo back of the base, and will be printed on the front of the encourages you to dispose of it properly.
  • Page 16: Limited Warranty

    Evenflo’s sole obligation under this express limited warranty shall be, at Evenflo’s option, to repair or replace any Product that is determined to be defective by Evenflo and determined to be covered by this warranty.
  • Page 17 Answers. Advice. Affirmation. ™ • www.evenflo.com • USA: 1-800-233-5921 8 AM – 5 PM EST • Mexico: 01-800-706-12-00...

Table of Contents