Installation Checklist - Evenflo Embrace 35 Owner's Manual

Proper Installation
WITH
the Convenience Base
Child Requirements
Weight: 1.8 – 15.8 kg (4 – 35 lbs)
Height: Top of head must be at least 25 mm (1 inch)
below the top of the child restraint seat back.
Lower Anchor
Connector Assembly/
Vehicle Belt Path
T !
T !
IP
IP
To make installation easier, watch the installation
video of this child restraint at www.evenflo.com.
At least 25 mm
(1 inch)
Harness straps at, or
below, the shoulder.
18

Installation Checklist

1. Secure convenience base to the
vehicle seat.
a
Convenience base is securely installed with
lower anchor connector assembly (shown)
(pages 20-22).
OR
a
Convenience base is securely installed with
vehicle seat belt (pages 23-25).
IMPORTANT: A properly secured convenience base
does NOT move more than 25 mm (1 inch) from
side-to-side or from front-to-back at the lower
anchor connector assembly/vehicle belt path.
a
Locking clip is installed, if necessary (p. 41).
a
Convenience base is adjusted so that level
indicator is completely green (pp. 21 and 23).
a
If necessary, a towel/small blanket is rolled up
and placed beneath the front edge of the base
for additional leveling (p. 26).
2. Secure child to the carrier.
a
Harness straps are at, or below, shoulder level
(p. 36).
a
Both buckle tongues are fastened (p. 33).
a
Chest clip is connected and positioned at
armpit level (p. 34).
a
Harness straps are snug against the child and you
should not be able to pinch the harness (p. 34).
a
Crotch strap is snug against the child but
NOT under the child's bottom (p. 38).
3. Check your work.
a
The convenience base does
than 25 mm (1 inch) from side-to-side or from
front-to-back at the lower anchor connector
assembly/vehicle belt path.
a
The base is level with only green (no red)
showing in the level indicator window (pp. 21
and 23).
a
The handle is in Position 1 (Canadian OR U.S.
models) or Position 4 (U.S. models ONLY) (p. 26).
(Position 4 shown at left.)
Refer to p. 33.
NOT move more
19