Installing The Carrier Without The Convenience Base - Evenflo Embrace 35 Owner's Manual

Installing the Carrier without the
Convenience Base
1
After securing the infant, place the restraint into your
vehicle. Adjust the restraint so that the level line
parallel with the vehicle floor.
Note: Generally, the center rear seating position is the
safest. This infant restraint
the vehicle.
2
Move the handle out of the way by squeezing both
handle releases and placing in Position 4.
B
A
A
MUST face the rear of
Position 4
B
30
3
LAP BELT
C
Route ONLY the lap portion of the vehicle seat belt
through the vehicle belt slots
In vehicles with a lap and shoulder belt
route the shoulder belt through the belt slots. Instead,
let it lay across the vehicle seat back, as shown.
IMPORTANT: Some ELR vehicle belts can be switched so
is
that they lock when tightened. It may not be necessary
to use a locking clip in these situations.
To install a locking clip, refer to p. 41.
Refer to the vehicle owner's manual to determine which
type of belt retractor is in the vehicle.
4
• NEVER use this child restraint in forward-facing position.
• DO NOT
(1 inch) side-to-side or front to back at the vehicle belt
path. Serious injury or death may occur. Move the child
restraint to another seating location, or try to tighten
the vehicle belt again.
The vehicle belt
full weight into the seat as you tighten the vehicle belt.
If you can move the child restraint more than 25 mm
(1 inch) side-to-side or front to back at the vehicle belt
path, the vehicle belt is not tight enough, and you need
to try again.
LAP AND
SHOULDER BELT
D
on the carrier.
C
E
WARNING
use this carrier if it moves more than 25mm
must be as tight as possible. Put your
E
31
, DO NOT
D
T T ! !
IP IP
Push down on
the bottom of the
seat using your
full weight.