Evenflo Embrace 35 Owner's Manual page 28

Installing Convenience Base in Aircraft
2
F
Secure the base to the aircraft seat by routing
the aircraft seat belt through the openings
sides of the base.
3
A
The aircraft seat belt must be as tight as possible.
A
Route the excess seat belt strap
belt slots , as shown above. Using your full weight,
B
push the base firmly onto the aircraft seat while pulling
on the excess seat belt strap to tighten.
Check your work. Try to move the base in all
directions. If you can move the base more than 25
mm (1 inch) side-to-side or front to back at the belt
path , the aircraft seat belt
B
and you MUST install again until the seat belt is tight.
on the
F
B
D
back through the
D
is not tight enough,
A
52
Installing Convenience Base in Aircraft
4
Placing the Carrier in the Base
5
Squeeze both handle releases
to Position 1.
Unfasten SensorSafe Chest Clip
6
Secure the carrier to the
base by placing it into
the base and pressing
down on the front and
back.
The carrier MUST be
locked firmly into the
base. Check by lifting
up on the carrier handle
or the front of the
carrier to make sure it's
locked in place.
Position 1
C
and move the handle
C
As a final step, unfasten
the chest clip (p. 35).
In order to comply
with the FAA regulation
for Portable Electronic
Devices (PED), the
SensorSafe Chest Clip
MUST be unfastened
before take-off.
53