Installing The Canopy - Evenflo Embrace 35 Owner's Manual

Installing Carrier without Convenience
Base in Aircraft
5
D
A
The aircraft seat belt must be as tight as possible.
A
Route the excess seat belt strap
belt slots , as shown above. Using your full weight,
B
push the child restraint firmly onto the aircraft seat
while pulling on the excess seat belt strap to tighten.
Check your work. Try to move the child restraint in
all directions. If you can move the child restraint more
than 25 mm (1 inch) side-to-side or front to back at
the belt path , the aircraft seat belt
B
enough, and you MUST
belt is tight.
6
Position 1
Unfasten SensorSafe Chest Clip
7
B
back through the
D
is not tight
A
install again until the seat
Squeeze both handle
releases and move
C
the handle to Position 1.
C
As a final step, unfasten
the chest clip (p. 35).
In order to comply
with the FAA regulation
for Portable Electronic
Devices (PED), the
SensorSafe Chest Clip
MUST be unfastened
before take-off.
56

Installing the Canopy

Insert front canopy end
A
Repeat on the other side.
Installing the Accessories
1
B
A
The optional Head Support
the seat back, as shown.
Be sure to cut off the plastic attachment between the
head support and the seat pad. Small parts may be a
choking hazard.
IMPORTANT:
Support the child's head. Infants may have difficulty
breathing when in a sitting position. Using additional
padding or pillows behind the infant's head, or failure
to properly recline the child restraint could increase the
child's risk of serious injury or death.
A
B
into the holder .
B
Not available on all models.
The optional Body
Pillow A is used to help
support your child by
placing it in the restraint,
as shown.
B should lie flat against
57