Manual Registration; Gigaset 1000 To 4000 And Other Gap-Supported Handsets; De-Registering Handsets - Siemens Gigaset S100 User Manual

The base station search is terminated after 60 seconds. If registration is not completed
in this period, repeat the process.
After successful registration, the handset is assigned the next available number, as
described in the chapter "Automatic registration" (page 82).

Manual registration:

Gigaset 1000 to 4000 and other GAP-supported handsets

The following describes how to register Gigaset family handsets, handsets A 2, C 1, C 2
or other GAP-supported handsets at your S 100/S 150.
1. At the handset
Start handset registration as described in its operating instructions.
2. At the base station
During registration, the next unassigned internal number (1–6) is automatically
assigned to the handset. If all 6 are assigned, number 6 will be overwritten if this hand-
set is in the idle state.

De-registering handsets

You can de-register any registered handset using any other registered S 1 handset.
[______________________________________________]
De-reg. H/Set No.
OK
[RRRRRRRRRR]
Yes
Registering and de-registering handsets
Press the Register/Paging key on the base station
(page 64) , until you hear a signal tone (only S 150)
(about 3 seconds). This starts the registration proce-
dure.
Open the handset list.
Internal
________
______1
Call All
INT 1
Anna
Select the handset to be de-registered (your handset
is marked with <) and open the menu.
Select the menu item and confirm.
OK
Enter the system PIN (factory setting: 0000) and con-
firm.
Press the display key to confirm the prompt.
The handset you are using
is marked with <.
<
83