Registering And De-Registering Handsets; Automatic Registration: Gigaset S 1 To Gigaset S 100 Or S 150; Manual Registration: Gigaset S 1 To Gigaset S 100 Or S 150 - Siemens Gigaset S100 User Manual

Registering and de-registering handsets

Registering and de-registering handsets
You can register up to six handset at your base station.
An unregistered S 1 handset is registered automatically. Handsets of the Gigaset 1000,
2000, 3000, 4000 families and non-Siemens handsets must be registered manually.
An S 1 handset can be registered at up to four base stations.

Automatic registration: Gigaset S 1 to Gigaset S 100 or S 150

Automatic registration is possible for any handset that is not registered at a base station.
To "introduce" your handset, place it in the base station with the display facing
upward. The registration process takes about a minute. During registration the display
shows Regstr.Procedure and it flashes Base 1. The next unassigned internal number
(1–6) is automatically assigned to the handset. After successful registration, the dis-
play shows this internal number, e.g. "INT 1". This means that the handset has been
assigned the first internal number. If all the internal numbers (1 – 6) have already been
assigned (six handsets have been registered at the base station, number 6 will be over-
written if this handset is idle).
Automatic registration is only possible if the base station you want to
N
register the handset at is not being used for a call.
i
You can assign a different internal number (page 86) or name
N
(page 85) to a registered handset.

Manual registration: Gigaset S 1 to Gigaset S 100 or S 150

You have to initiate registration at the handset and at the base station.
1. At the handset
[______________________________________________]
H/Set Settings
[______________________________________________]
Register H/Set
[______________________________________________]
Base 1
OK
After entering the system PIN, Base 1 flashes in the display, for example.
2. At the base station
82
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Select the base station (1–4) and confirm,
OK
e.g. Base 1.
Enter the base station system PIN (factory setting:
0000) and confirm.
Press the Register/Paging key on the base station
(page 64) , until you hear a signal tone (only S 150)
(about 3 seconds). This starts the registration proce-
dure.