Setting The Walk And Talk Mode - Siemens Gigaset S100 User Manual

Deactivating the room monitor
You can deactivate the room monitor remotely. Accept the alarm call sent by the room
monitor function and enter O R. The function is deactivated about 90 seconds
after the end of the call. No more room monitor alarms will be sent. The other room
monitor functions on the handset (e.g. no ring tone) will remain active until you press
the display key on the handset in the baby's room.
Off
To re-activate the room monitor function with the same telephone
i
number, you have to activate it again and save the setting with

Setting the Walk and Talk mode

The Walk and Talk function enables communication between two handsets no matter
how far away from the base station they are.
Example: you go on holiday and take two Walk and Talk enabled handsets with you.
Activate the Walk and Talk function on both handsets. Then you can use them for com-
municating.
Prerequisite:
Both handsets are registered at the same base station or
N
both handling are registered at different base stations and set to Best Base
N
(page 84) or
one of the handsets is not registered at any base station and the registered handset
N
is set to Best Base or
neither handset is registered at a base station.
N
In Walk and Talk mode
the maximum range between the handsets out in the open is 300 m,
N
i
the handsets are no longer available for incoming calls,
N
the operating time of the handsets is considerably reduced.
N
Operating several handsets
Save
.
93