Siemens Gigaset S100 User Manual page 116

Appendix
What has happened if ... Possible cause
... (if several handsets are
used) the handset in the base
station does not charge?
... the handset or the base sta-
tion S 150 does not ring?
... I cannot hear any ringer/
dialling tone?
... the units/call charges are
not displayed?
... the call charge is not dis-
played?
... the other person cannot
hear me?
... the incoming call number is
not displayed although CLIP is
set?
... the error beep is heard
while making an entry (rising
tone sequence)?
... I cannot listen to the net-
work mailbox?
... an answering machine
message does not have a time
stamp?
... the answering machine
says "PIN is incorrect" during
remote operation?
... the answering machine
does not record any messages
or has automatically switched
to announce only mode?
... voice command does not
work?
112
A handset cannot be charged
while a telephone call is being
made.
The ringer tone is switched off.
Call diversion has been set to All
Calls.
You have changed the telephone
cord on your Gigaset.
There are no metering pulses.
The charge per unit set to
"00.00".
You have pressed the
u
key. This "mutes" the handset.
The calling line identification is
not enabled.
The action has failed or the input
is incorrect.
Your PABX system is set to dial
pulsing.
The date/time are not set.
The system PIN entered is incor-
rect or still set to 0000.
Its memory is full.
You are too far from the handset:
The background noise is too
loud.
Possible solution
Use an additional charging
unit.
Activate the ringer tone of the
handset (page 96) or the base
stationS 150.
Switch off call diversion
(page 2).
Ensure, when purchasing a
new cord, that it has the cor-
rect pin assignment (page 8).
Ask your network provider to
transmit the metering pulses.
Set call charge per unit
(page 4).
(INT) Re-activate the microphone
(page 22).
The caller should permit call
line identification (CLI) by his
or her telephone company.
Repeat the procedure; read the
display message and, if neces-
sary, refer to the operating
instructions.
Switch the PABX system to tone
dialling (page 110).
Set the date/time (page 15).
Re-enter the system PIN or set a
PIN other than 0000
(page 102).
Delete old messages.
Play back and delete new mes-
sages.
Reduce the distance to handset
to about 20 cm.
Record your voice patterns in
quieter surroundings.