The Wps Screen - ZyXEL Communications VMG4381-B10A User Manual

Figure 37 Wireless > MAC Authentication
The following table describes the labels in this screen.
Table 23 Wireless > MAC Authentication
LABEL
SSID
MAC Restrict
Mode
Add new MAC
address
#
MAC Address
Modify
Apply
Cancel

7.5 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The Device applies the security settings of the SSID1 profile (see
page
security mode of SSID1 to WPA-PSK, WPA2-PSK or No Security.
Chapter 7 Wireless
DESCRIPTION
Select the SSID for which you want to configure MAC filter settings.
Define the filter action for the list of MAC addresses in the MAC Address table.
Select Disable to turn off MAC filtering.
Select Deny to block access to the Device. MAC addresses not listed will be allowed to
access the Device.
Select Allow to permit access to the Device. MAC addresses not listed will be denied access
to the Device.
Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
Device in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
This is the index number of the entry.
This is the MAC addresses of the wireless devices that are allowed or denied access to the
Device.
Click the Delete icon to delete the entry.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Section 7.10.9.3 on page 127
102). If you want to use the WPS feature, make sure you have set the
VMG4381-B10A User's Guide
for more information about WPS.
112
Section 7.2 on