Table of Contents
Advertisement
Use this screen to view your Device's MAC filter settings and add new MAC filter rules. Click
Network Setting > Wireless > MAC Authentication. The screen appears as shown.
Figure 36 Wireless > MAC Authentication
The following table describes the labels in this screen.
Table 23 Wireless > MAC Authentication
LABEL
SSID
MAC Restrict
Mode
Add new MAC
address
#
MAC Address
Delete
Apply
Cancel
6.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
VMG1312-B10C User's Guide
DESCRIPTION
Select the SSID for which you want to configure MAC filter settings.
Define the filter action for the list of MAC addresses in the MAC Address table.
Select Disable to turn off MAC filtering.
Select Deny to block access to the Device. MAC addresses not listed will be allowed to
access the Device.
Select Allow to permit access to the Device. MAC addresses not listed will be denied access
to the Device.
Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
Device in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
This is the index number of the entry.
This is the MAC addresses of the wireless devices that are allowed or denied access to the
Device.
Click the Delete icon to delete the entry.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Section 6.10.9.3 on page 95
Chapter 6 Wireless
for more information about WPS.
79
Advertisement
Table of Contents
