The Wps Screen - ZyXEL Communications VMG3312-T20A User Manual

Figure 41 Network Setting > Wireless > MAC Authentication
The following table describes the labels in this screen.
Table 24 Network Setting > Wireless > Authentication
LABEL
General
SSID
MAC Restrict
Mode
MAC address List
Add new MAC
address
#
MAC Address
Modify
Apply
Cancel

7.5 The WPS Screen

Use this screen to configure WiFi Protected Setup (WPS) on your VMG.
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Set up each WPS connection between two devices. Both devices must
support WPS. See
Chapter 7 Wireless
DESCRIPTION
Select the SSID for which you want to configure MAC filter settings.
Define the filter action for the list of MAC addresses in the MAC address list.
Select Disable to turn off MAC filtering.
Select Deny to block access to the VMG. MAC addresses not listed will be allowed to access
the VMG.
Select Allow to permit access to the VMG. MAC addresses not listed will be denied access to
the VMG.
Click this if you want to add a new MAC address entry to the MAC filter list below. This button is
not configurable when you select Disable in the MAC Restrict Mode field.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
VMG. Enter the MAC addresses in a valid MAC address format, that is, six hexadecimal
character pairs, for example, 12:34:56:78:9a:bc.
This is the index number of the entry.
This is the MAC addresses of the wireless devices that are allowed or denied access to the
VMG.
Click the Edit icon to change the MAC address.
Click the Delete icon to remove the entry.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
Section 7.9.8.3 on page 118
VMG3312-T20A User's Guide
for more information about WPS.
105