Table of Contents
Advertisement
Table 16 Wireless > MAC Authentication (continued)
LABEL
Add new MAC
address
#
MAC Address
Modify
Apply
Cancel
6.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The Device applies the security settings of the SSID1 profile (see
page
mode of SSID1 to WPA2-PSK or WPA-PSK/WPA2-PSK mixed or no security.
VMG1312-T10C User's Guide
DESCRIPTION
Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
Device in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Figure 34 Wireless > MAC Authentication > Add new MAC address
This is the index number of the entry.
This is the MAC addresses of the wireless devices that are allowed or denied access to the
Device.
Click the Delete icon to delete the entry.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Section 6.10.7.3 on page 80
57). If you want to use the WPS feature, make sure you have set the security
Chapter 6 Wireless
for more information about WPS.
Section 6.2 on
67
Advertisement
Table of Contents
