ZyXEL Communications VMG4381-B10A User Manual page 136

Figure 52 Network Setting > Home Networking > LAN Setup
The following table describes the fields in this screen.
Table 31 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
Interface Group
Group Name Select the interface group name for which you want to configure LAN settings. See
13 on page 201
LAN IP Setup
IP Address Enter the LAN IP address you want to assign to your Device in dotted decimal notation, for
example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your Device automatically computes the subnet mask
based on the IP Address you enter, so do not change this field unless you are instructed to
do so.
IGMP Snooping
Status Select the Enable IGMP Snooping checkbox to allows the Device to passively learn
multicast group.
IGMP Mode Select Standard Mode to have the Device forward multicast packets to a port that joins the
multicast group and broadcast unknown multicast packets from the WAN to all LAN ports.
Select Blocking Mode to have the Device block all unknown multicast packets from the
WAN.
DHCP Server State
DHCP Select Enable to have the Device act as a DHCP server or DHCP relay agent.
Select Disable to stop the DHCP server on the Device.
Select DHCP Relay to have the Device forward DHCP request to the DHCP server.
Chapter 8 Home Networking
for how to create a new interface group.
VMG4381-B10A User's Guide
136
Chapter