The 8021X Screen - ZyXEL Communications VMG4381-B10A User Manual

Table 13 Network Setting > Network Setting > Broadband (continued)
LABEL
PhyR US
PhyR DS
Apply
Cancel

6.5 The 8021x Screen

You can view and configure the 802.1x authentication settings in the 8021x screen. Click Network
Setting > Broadband > 8021x to display the following screen.
Figure 28 Network Setting > Broadband > 8021x
The following table describes the labels in this screen.
Table 14 Network Setting > Network Setting > 8021x
LABEL
#
Status
Interface
EAP Identity
EAP method
Bidirectional
Authentication
Certificate
Trusted CA
Apply
Cancel
Chapter 6 Broadband
DESCRIPTION
Enable or disable PhyR US (upstream) for upstream transmission to the WAN. PhyR US
should be enabled if data being transmitted upstream is sensitive to noise. However,
enabling PhyR US can decrease the US line rate. Enabling or disabling PhyR will require the
CPE to retrain. For PhyR to function, the DSLAM must also support PhyR and have it
enabled.
Enable or disable PhyR DS (downstream) for downstream transmission from the WAN.
PhyR DS should be enabled if data being transmitted downstream is sensitive to noise.
However, enabling PhyR DS can decrease the DS line rate. Enabling or disabling PhyR will
require the CPE to retrain. For PhyR to function, the DSLAM must also support PhyR and
have it enabled.
Click Apply to save your changes back to the Device.
Click Cancel to return to the previous configuration.
DESCRIPTION
This is the index number of the entry.
This field displays whether the authentication is active or not. A yellow bulb signifies that
this authentication is active. A gray bulb signifies that this authentication is not active.
This is the interface that uses the authentication. This displays N/A when there is no
interface assigned.
This shows the EAP identity of the authentication. This displays N/A when there is no EAP
identity assigned.
This shows the EAP method used in the authentication. This displays N/A when there is no
EAP method assigned.
This shows whether bidirectional authentication is allowed.
This shows the certificate used for this authentication. This displays N/A when there is no
certificate assigned.
This shows the Trusted CA used for this authentication. This displays N/A when there is no
Trusted CA assigned.
Click Apply to save your changes back to the Device.
Click Cancel to return to the previous configuration.
VMG4381-B10A User's Guide
95