Table of Contents
Advertisement
15.
MAIntenAnCe, CAre And rePAIr
storage and transportation
Remove the magic.tapes.for.the.stabilizer.and.lower.the.aluminium.profile.for.storage.and.transportation.
regular cleaning
The.RC.EYE.650.is.a.very.simple.but.nonetheless.well-designed.flying.device..There.are.no.mechanical.parts.that.need.to.be.lubricated.or.
require.special.maintenance..However,.after.each.flight.operation.you.should.clean.the.RC.EYE.650.of.possible.dirt.(grass.blades,.dust.etc.).
For cleaning, use a dry or slightly damp cloth and avoid contact between water and the electronics, rechargeable battery and motors.
Do.not.fly.without.covering.the.electronics..Ensure.that.no.moisture.enters.the.inner.central.piece.(e.g..wet.grass.blades.etc.).Never.fly.when.
it is raining!
replacing the propellers
If.a.propeller.is.damaged.in.a.crash.or.other.action,.replace.it.immediately..This.also.applies.if.there.are.any.fine.tears.or.grazing.in.the.
propeller. Due to the high speed, material parts could come loose if the propellers are damaged and this could lead to damage to or
endangerment of the environment.
To change a propeller, remove the spinner and the wave washers and the faulty propeller. Carry out the mounting of the new propeller as
described in the chapter "Assembly > Assembly of the propellers".
observe the rotating direction of the respective motor and choose the correct propellers. If they are incorrectly chosen,
the model will not be able to fly and will act in an erratic way when next started! Loss of guarantee/warranty!
replacing a motor
If a motor is defective (overheating, electrical fault or bearing failure), this must be replaced. For this purpose, carry out the following steps
as.specified:
1.
Remove the spinner, wave washer and propeller from the faulty motor.
2.
Remove the canopy.
3.
Remove the stabilizer and the top body frame by loosening the screws. Now you have free access to the motor driver board. Detach the
bullet connector from the faulty motor.
P. 34
Advertisement
Table of Contents
