Table of Contents
Advertisement
Programming of transmitter Channels (general)
QC-09
LD1
LD2
>
LD1 (the green LED)
>
LD2 (the red LED)
>
X5:.Interface.to.extension.boards
>
X1.and.X2:.Interface.to.motor.drivers
Before.you.begin.programming,.unplug.the.rechargeable.battery,.if.connected,.from.the.RC.EYE.650..Also.disconnect.the.connection.cable.
to.the.PC,.if.connected,.from.the.RC.EYE.650..
1.
Switch.the.DIP.4.on.the.QC-09.to.ON.position..On.one.side.of.the.QC-09,.both.of.the.LEDs.(LD1,.LD2).indicate.particular.operating.statuses..
Before switching the transmitter on, set the throttle stick to "motors off" and all trim levers / trim sliding controllers of the
pilot stick to the neutral position. otherwise, the rC eye 650 may not recognise the transmitter after the battery is connected.
2.
Now switch on the transmitter.
Ensure that all levers and trims of the transmitter are in neutral position. The example given shows the procedure using a remote control
in.mode.2..If.you.prefer.to.use.another.mode,.the.axes.used.may.differ.(see.chapter."Possible.flight.modes")!.Also ensure that the sliding
controller for the trim is set to neutral position! Otherwise correct recognition of the channels will not be possible!
Ensure that lever movements are made in the right direction, otherwise the signals will be memorised in reverse! Computer remote
controls should always be operated without mixer!
3.
Move.the.throttle.lever.backwards.to.the.neutral.position.(motor.off),.all.other.control.devices.should.be.set.to.neutral..
4.
Do.you.want.to.try.out."nick.reverse"?.(During."motor.off".the.pilot.stick.for.throttle.is.pulled.away.from.the.body),.then.bring.the.throttle.
lever forwards into the max. position before you connect the rechargeable battery.
Programming of "throttle"
1.
Connect.the.charged.battery.to.the.RC.EYE.650..The.model.starts.with.a.self-test.and.directly.continues.with.programming.of.the.channels..
On.the.basis.of.the.throttle.setting,.the.RC.EYE.650.automatically.recognizes.which.channel.you.would.like.to.use.for.the.throttle..
2.
As.confirmation,.the.red.LED.(LD2).on.the.combined.flight.control.board.will.flash,.twice.in.a.cycle.
X1
X5
X2
dIP switches
1.
Parameter settings sport
2.
Parameter settings user
3.
Boot loader mode
4.
RC.configuration
5.
No.function.yet.defined
6.
No.function.yet.defined
DIP 6, 5, 4, 3, 2, 1
P. 25
Advertisement
Table of Contents
