Maintenance, Care And Repair - RC Logger RC EYE One Operating Instructions Manual

1. Switch off the transmitter.
2. Push the button for channel selection for more than three seconds. A sound signal is emitted. The
number of sound signals indicates the transmitter channel number. A sound signal means transmitter
channel 1, two sounds signals mean transmitter channel 2, etc.
3. Now release the button. Then push the button repeatedly until the desired transmitter channel (e.g. 3
sound signals = transmitter channel 3) is set.
4. Confirm.the.new.transmitter.channel.by.pushing.the.on/off.button..The.programming.is.confirmed.by.a.
single sound signal.
5. Now.bind.the.transmitter.and.model.as.described.in.chapter.BINDING.FUNCTION.

14. MAINTENANCE, CARE AND REPAIR

Regular Cleaning
The.""RC.EYE.One"".is.a.very.simple.but.nonetheless.well-designed.flying.device..There.are.no.mechanical.
parts.that.need.to.be.lubricated.or.require.special.maintenance..However,.after.each.flight.operation.you.
should clean the ""RC EYE One"" of possible dirt (wool strings, dust, etc.).
For cleaning, use a dry or slightly damp cloth and avoid contact between water and the electronics,
rechargeable battery and motors.
Do.not.fly.without.covering.the.electronics..Please.ensure.that.no.moisture.enters.the.inner.central.piece..
Never.fly.when.it.is.raining!
Replacing the Rotors
Attention!
Observe the rotating direction of the respective motor and the choice of the
corresponding rotor without fail. If these are incorrectly chosen, the model will not be
able to fly and will act in an erratic way when next started! Loss of guarantee/warranty!
The rotating direction is marked on the rotors ("L" or "R"). The mark "L" or "R" points
up.
The rotors marked "L" must be installed on the motors that turn leftwards (counter
clockwise).
The rotors marked "R" must be installed on the motors that turn rightwards (clockwise).
If a rotor is damaged in a crash or other action, replace it immediately. This also applies if there are any
fine.tears.or.grazing.in.the.rotor..Due.to.the.high.speed,.material.parts.could.come.loose.if.the.rotors.are.
damaged and this could lead to damage to or endangerment of the environment.
1. To replace a rotor, pull the damaged rotor from the motor shaft and replace it with a new one. The
rotors must not be pushed completely onto the motor shaft. Keep about 0.5 mm distance from the
motor housing.
31